User manual

DSO-1052 USB
DSO-1082 USB
The Pass/Fail function display:
Caution: Pass/Fail function unavailable in X-Y mode and Roll mode.
4.3 Capturing a Single-Shot Signal
ther some pre-test knowledge of the signal in
rectly. For example, if the event is derived
should work on a rising edge.
ps as follows:
1. Set the probe and the channel attenuations to X 10.
2. Set up the trigger in the Trigger Menu, or in the Trigger Setting window.
)Set the Trigger Source to CH1.
)Set the Trigger Slope to “+” which means you select the rising edge.
)Adjust the Volts/Div and the time base in a proper range for the signal.
)Drag the trigger level sign on the waveform display screen to proper position. It ally
igher a little above the normal level.
)Click START button to start capturing. When the trigger conditions are met, data
To capture a single event, it needs to ga
order to set up the trigger level and slope cor
from 3.3V COMS logic, a trigger level of 1.2 or higher Volts
Do these ste
(1)Adjust the Trigger Mode to Edge.
(2)Set the Trigger Sweep to Single.
(3
(4
(5
(6
h
(7
USER’S MANUAL 73