Manualshelf

User manual

ManualsBrandsVOLTCRAFT ManualsLaboratory Test EquipmentPC scope module DSO-2150AL 80 MHz 2-channel 250 null 64 null 8 Bit Digital storage (DSO), Spectrum analyzer
11121314151617181920
DSO-1052 USB
DSO-1082
USB
1.7 Function Check
Perform this functional check to
verify that your oscilloscope is operating correctly. verify that your oscilloscope is operating correctly.
Connect the oscilloscope Connect the oscilloscope
You should connect the A-Type Plug of USB cable to your PC USB port and connect
the B-Type Plug of USB cable to oscilloscope USB port.
You should connect the A-Type Plug of USB cable to your PC USB port and connect
the B-Type Plug of USB cable to oscilloscope USB port.
Input a sign
al to a channel of the o
scilloscope
The oscilloscope is equipped with two channels plus external trigger.
Please input signal in the following steps:
1. Set the attenuation switch on the probe as 10X and connect the probe on the
oscilloscope with CH1. Aim the slot in the probe connector at the faucet on BNC of CH1
and insert, then, turn right to lock the probe. Finally, attach the tip of probe and ground nip
to the Connector of Probe compensator.
2. Set the CH1 probe attenuation of the oscillosco
pe to X10. (The default is X1).
U
S
ER’S MANUAL 16