User manual

Voltsoft User Manual Version 2.4
108
6.12.4 DL191A – Settings
1
Time
Configure the device data time value.
The user can specify a defined time or use the system
date time.
2
Logger Name
Input the unique alias for that device.
3
Record Start Condition
By Button – The data logger will start recording only
after the user pressed the red button on
the device.
After Setup – The data logger will start recording
immediately after setup.
4
Sample Points
Configure the data logger sample points.
5
Sample Rate
Instruct the data logger to log readings at a specific
rate.
6
Record LED Flash
Configure the LED flash cycle - the longer the time, the
longer the battery life.
7
Enable LED Alert
Enable / disable LED flash when the alarm is triggered.
8
Low / High Alarm
Configure the low / high alarm level for current.
9
Default Button
Load the factory default settings.
10
Setup Button
Save changes.
11
Close Button
Close this interface.