User manual



The power supply can be remote controlled with an external potentiometer (5 kOhm) over the entire range for
voltage and current.
Connect the connection lines to the remote sockets as illustrated.
 
• Connection 1 at one end of the resistor. • Connection 1 at the end of the resistor.
• Connection 2 at the middle sliding contact of the
resistor.
• Connection 3 at the middle sliding contact of the
resistor.
• Connection 4 at the second end of the resistor. • Connection 4 at the second end of the resistor.


The DC output can be switched on and off via a switch contact. Proceed as follows for the connection:
1. Connect the connection lines to the remote sockets as illustrated.
2. Connect the 4 and 5 connection to a potential free switch contact.
3. The status displays  and  ash when the output is switched off. In addition the display (2) indicates the
current settings of the output voltage and output current.
4. You can determine the output values with the setting controller for voltage  (4) and current limitation
 (5) when the output is switched off.
