User manual
1. Switch off the power supply and then connect the remote socket to the rear remote control socket
(10). Screw together the external fastening ring.
2. Control the voltage of the external voltage source at 0 V.
3. Switch on the power supply.
4. Hold the (8) button for approx. 3 seconds.
5. Turn the setting controller (4) until the following display appears:
6. Then press the setting controller (4) to reach the setting mode.
7. Turn the setting controller (4) to switch the remote control on or off. ON or OFF appears in the right
display.
8. Press the (8) button to conrm the selection and leave the setting mode.
All illuminated function buttons (8) determined after the remote control mode was activated.
The (8) button and the LED remote control display (3) light up.
9. To deactivate the remote control mode press the (8) button, to activate all function buttons (8).
10. Repeat steps 4 to 8.
The power supply can be remote controlled with an external voltage source of 0 to 5 V/DC over the entire range for
voltage and current.
Connect the connection lines to the remote sockets as illustrated.
V
• Connection 2 to the positive pole (+) of the external
control voltage.
• Connection 3 to the positive pole (+) of the external
control voltage
• Connection 4 to the negative pole (-) of the external
voltage source.
• Connection 4 to the negative pole (-) of the external
voltage source