User manual

16
ENERGY METER4.
The energy cost measuring device is intended for measuring and analysing consumption details of electrical devices. The measuring
device is connected easily between the mains socket and the electric device and requires no additional installation. It is only to be
used with standard domestic mains sockets with a nominal voltage of 230 V/AC. The max. nominal performance must not exceed
3680 watts.
To calculate the costs, the current valid electricity rate can be entered. Further, the device provides a cost forecast per day/month/
year. The consumption details can be displayed and adjusted on the device even when it is unplugged from a power socket. To do
this, the device contains two button cell batteries. The device is only to be used with the specied batteries.
The measuring device is not ofcially calibrated and therefore must not be used for billing purposes.
Description of the Parts
Protective-earth contact socket with child protection1.
230 3680
6.20
V WW
TO TA L kWh
1
2
3
4
65
7
8
9
SET
Control and setting key2. ▼(downwards)
Control and setting key 3. ▲(upwards)
Display: Display area “Bottom”4.
Display: Display area “Left”5.
Display: Display area “Right”6.
Rear battery compartment7.
“SET” key for parameter setting8.
Control and setting key 9. ● (Conrmation)
Display indications and Symbols
▲
Up symbol
▼
Down symbol
●
Conrmation symbol
SET Adjustment
MAX Maximum value display
POWER FACTOR Display of the power factor CosPhi
TOTAL Total value
COST Cost display
TIME The actual operating time for the electric consumer load, e. g. forfridges.
FORECAST Calculated cost forecast
DAY Cost forecast per day
MONTH Cost forecast per month
YEAR Cost forecast per year
V Volt (unit for electric tension)
A Ampere (unit for electric current)
Hz Hertz (unit for frequency)
W Watt (unit for effective power)
COS Power factor (factor for the phase displacement of V and A)
kWh Kilowatt hour (unit for the electrical work, consumed power per hour)
Inserting/Replacing the Batteries
Before using for the rst time or when the display does not show any values after pressing the button, the coin cell batteries must
be inserted or replaced. The batteries are used to ensure that the set parameters and measured values are saved in the device
even when it is unplugged.
The battery compartment (7) must only be opened if the device is unplugged.