Operation Manual

The voltage in one of the cells of a LiPo, LiIon, LiFe

accumulator is too high. This can occur if a multicell

accumulator has been charged previously without

a balancer.

The balancer cable was connected wrong or does

not fit to the pin assignment of the charger.

Excess temperature detected. Leave the charger

and the accumulator to cool down.

The charger has established that there is an internal

problem. Should this message permanently be

displayed, it is possible that the charger is defective;

have it checked by a specialist workshop or qualified

technician.

BATTERY VOLTAGEBATTERY VOLTAGE

BATTERY VOLTAGE

CELL HIGH VOLCELL HIGH VOL

CELL HIGH VOL

BATTERY VOL ERRBATTERY VOL ERR

BATTERY VOL ERR

CELL CONNECTCELL CONNECT

CELL CONNECT

TEMP OVER ERRTEMP OVER ERR

TEMP OVER ERR

CONTROL FAILURECONTROL FAILURE

CONTROL FAILURE