Operation Manual

87
17. Warning messages on the display
REVERSE POLARITYREVERSE POLARITY
REVERSE POLARITYREVERSE POLARITY
REVERSE POLARITY
CONNECTION BREAKCONNECTION BREAK
CONNECTION BREAKCONNECTION BREAK
CONNECTION BREAK
BATTERY CHECKBATTERY CHECK
BATTERY CHECKBATTERY CHECK
BATTERY CHECK
HIGH VOLTAGEHIGH VOLTAGE
HIGH VOLTAGEHIGH VOLTAGE
HIGH VOLTAGE
BATTERY CHECKBATTERY CHECK
BATTERY CHECKBATTERY CHECK
BATTERY CHECK
LOW VOLTAGELOW VOLTAGE
LOW VOLTAGELOW VOLTAGE
LOW VOLTAGE
BREAK DOWNBREAK DOWN
BREAK DOWNBREAK DOWN
BREAK DOWN
VOL SELECT ERRVOL SELECT ERR
VOL SELECT ERRVOL SELECT ERR
VOL SELECT ERR
INPUT VOL ERRINPUT VOL ERR
INPUT VOL ERRINPUT VOL ERR
INPUT VOL ERR
SHORT ERRSHORT ERR
SHORT ERRSHORT ERR
SHORT ERR
BATTERY VOLTAGEBATTERY VOLTAGE
BATTERY VOLTAGEBATTERY VOLTAGE
BATTERY VOLTAGE
CELL LOW VOLCELL LOW VOL
CELL LOW VOLCELL LOW VOL
CELL LOW VOL
The polarity of the accumulator poles has been
switched.
The connection to the accumulator has been
broken, e.g. if the accumulator has been
disconnected during the charging process.
A short-circuit has been established on the charger
output.
The input voltage (operating voltage) for the
charger is too low.
The voltage of a LiPo, LiIon, LiFe accumulator to
be charged is incorrectly configured.
The charger has established that there is an internal
problem. Should this message permanently be
displayed, it is possible that the charger is defective;
have it checked by a specialist workshop or
qualified technician.
During the charging process it has been established
that the accumulator has been totally discharged.
In this case you should check if the voltage of the
accumulator has been correctly set for the charging
process.
The voltage in one of the cells of a LiPo, LiIon, LiFe
accumulator is too low. This can occur if a multicell
accumulator has been charged previously without
a balancer.