Operation Manual

The setting “USB Enable” is without function and may not be used (in other versions of the

charger, this serves to switch the connection socket for the temperature sensor to a USB/

RS232 port).

Briefly press the button “Start/Enter”. The bottom display begins to flash.

With the buttons “INC” or “DEC”, you switch between the display “Temp Cut-Off” and “USB”.

(As described above, this is without function in this version of the charger. Do not use it!).

Confirm the selection by pressing the ”Start/Enter” button.

If “Temp Cut-Off” was selected, the small 3-pole connector serves as input for a temperature

sensor (not part of the delivery, must be ordered separately).

The temperature blinks (see ill. on the top left, “80C”). With the buttons “INC” or “DEC”, you

can set the temperature at which a subsequent charge or discharge process is terminated.

Save the setting by briefly pressing “Start/Enter”.

• With the "INC" button, you access the next setting (or with the button "DEC" the previous

setting). Return to the main menu with the button "Batt Type/Stop".

The accumulator may become quite hot using the cycle program (automatic charge/

discharge cycles in sequence). Set a break time here to allow the accumulator to cool off

sufficiently.

Briefly press the button "Start/Enter". The time then begins to flash.

With the buttons "INC" or "DEC", you can select the time (1 to 60 min).

Save the setting with the button "Start/Enter"; the time stops blinking.

• With the "INC" button, you access the next setting (or with the button "DEC" the previous

setting). Return to the main menu with the button "Batt Type/Stop".

USB/Temp SelectUSB/Temp Select

USB/Temp Select

Temp Cut-Off 80CTemp Cut-Off 80C

Temp Cut-Off 80C

USB/Temp SelectUSB/Temp Select

USB/Temp Select

USB EnableUSB Enable

USB Enable

Waste TimeWaste Time

Waste Time

CHG>DCHG 1minCHG>DCHG 1min

CHG>DCHG 1min

Safety TimerSafety Timer

Safety Timer

ON 120minON 120min

ON 120min