Operation Manual

14. Saving accumulator data

The charger has altogether 5 memory slots in which you can save accumulator data/settings.

• In the main menu, select the function "SAVE DATA" with the button "Batt Type/Stop".

• Press the button "Start/Enter"; the display shows the following, for example, and memory

"01" blinks:

• Select the desired memory slot with the buttons "INC" or "DEC" (1....5) and confirm your entry

with the button "Start/Enter".

• Now the accumulator type, which you can change with the buttons "INC" or "DEC" blinks on

the top right of the display. Confirm the selection by pressing the "Start/Enter" button.



It is not possible to select between "LiPo", "LiIon" and "LiFe". The type set in

the user menu is always applied.

• The voltage starts to blink on the bottom left. Change this as usual using the buttons "INC"

and "DEC", confirm the value using the "Start/Enter" button.

• Now the accumulator capacity blinks on the bottom right. Set this with the buttons "INC" or

"DEC" (keep button depressed for fast changing) and confirm this with the button "Start/

Enter".

• Then the memory slot number blinks again.

• Keep the button "Start/Enter" depressed for approx. 3 seconds to access the next menu,

then let the button go again immediately. The following display appears (depending on the

previously selected accumulator type):



If you keep the button "Start/Enter" pressed too long, the display shows "SAVE"

and the settings are saved. Then restart the setting.

PROGRAM SELECTPROGRAM SELECT

PROGRAM SELECT

SAVE DATA SAVE DATA

SAVE DATA

SAVE [01] LiPoSAVE [01] LiPo

SAVE [01] LiPo

3.7V 2000mAh 3.7V 2000mAh

3.7V 2000mAh

NiMH CHARGE At*NiMH CHARGE At*

NiMH CHARGE At*

CUR LIMIT 4.0ACUR LIMIT 4.0A

CUR LIMIT 4.0A

LiPo CHARGE *LiPo CHARGE *

LiPo CHARGE *

1.0A 7.4V(2S)1.0A 7.4V(2S)

1.0A 7.4V(2S)