Operation Manual

51
2. Intended Use
The "Multi charger discharger B6" is used to charge NiCd + NiMH type batteries (1-16 cells),
LiPo/LiIon/LiFe batteries (1-6 cells) and lead acid batteries (1-10 cells, 2V-20V). The charge
current can be set between 0.1A and 5.0A depending on the connected accumulators and their
cell number/capacity.
Accumulators can also be discharged; the discharge current is between 0.1 to 1.0A.
The charger can either be operated with 11V - 18V DC current or with line voltage (100-240V~,
50/60 Hz). Do not connect the device to DC voltage and AC line voltage at the same time!
A two-line illuminated LCD display and four buttons are used to control the charger.
A balancer is integrated into the charger for LiPo/LiIon/LiFe batteries, with balancer connector
sockets for the accumulator located on the side of the charger.
The product is intended for use in dry indoors, it must not get damp or wet!
Any use other than that described above could lead to damage to this product and involves the
risk of short circuits, fire, electric shock, etc.
No part of the product should be modified or reassembled.
Observe all safety instructions and information within this operating
manual.
3. Contents
• Charger
• Connection cable with alligator clips (to connect to DC current)
• Power cord
• Connection cable set
• User’s manual