Operation Manual

62
16. Warning messages
REVERSEDREVERSED
REVERSEDREVERSED
REVERSED
POLARITYPOLARITY
POLARITYPOLARITY
POLARITY
CONNECTIONCONNECTION
CONNECTIONCONNECTION
CONNECTION
BREAKBREAK
BREAKBREAK
BREAK
BATTERY CHECKBATTERY CHECK
BATTERY CHECKBATTERY CHECK
BATTERY CHECK
OVER VOLTAGEOVER VOLTAGE
OVER VOLTAGEOVER VOLTAGE
OVER VOLTAGE
BATTERY CHECKBATTERY CHECK
BATTERY CHECKBATTERY CHECK
BATTERY CHECK
LOW VOLTAGELOW VOLTAGE
LOW VOLTAGELOW VOLTAGE
LOW VOLTAGE
BREAKDOWNBREAKDOWN
BREAKDOWNBREAKDOWN
BREAKDOWN
VOL SELECTVOL SELECT
VOL SELECTVOL SELECT
VOL SELECT
ERRERR
ERRERR
ERR
IN VOLTAGEIN VOLTAGE
IN VOLTAGEIN VOLTAGE
IN VOLTAGE
ERRERR
ERRERR
ERR
SHORT ERRSHORT ERR
SHORT ERRSHORT ERR
SHORT ERR
BATTERY VOLBATTERY VOL
BATTERY VOLBATTERY VOL
BATTERY VOL
ERRERR
ERRERR
ERR
The polarity of the battery poles has been switched.
The connection to the battery has been broken,
e.g. if the battery has been disconnected during
the charging process.
A short-circuit has been established on the charger
output.
The input voltage (operating voltage) for the
charger is too low.
The voltage of a LiPo battery to be charged is
incorrectly configured.
The charger has established that there is an internal
problem. Should this message permanently be
displayed, it is possible that the charger is defective;
have it checked by a specialist workshop or
qualified technician.
During the charging process it has been established
that the battery has been totally discharged.
In this case you should check if the voltage of the
battery has been correctly set for the charging
process.
The voltage in one of the cells of a LiPo battery is
too high. This can occur if a multicell LiPo battery
has been charged previously without a balancer.