User manual

• Only connect the power adaptor to a normal mains socket connected to the public

supply.Beforeplugginginthepoweradaptor,checkwhetherthevoltagestatedon

the power adaptor complies with the voltage of your electricity supplier.

• The power adapter must never be plugged in or disconnected when your hands

are wet.

• Never unplug the power adapter from the mains socket by pulling on the cable;

always use the grips on the plug.

• Whensetting up the product, ensure that the cable is not pinched, kinked or

damaged by sharp edges.

• Always lay the cables so that nobody can trip over or become entangled in them.

This poses a risk of injury.

• For safety reasons, disconnect the power unit from the mains socket during

storms.

• Always comply with the accident prevention regulations for electrical equipment

when using the product in industrial facilities.

• Inschools,trainingcentres,hobbyandself-helpgroups,theuseofchargersand

accessories must be supervised by trained personnel in a responsible manner.

• It is essential to pay attention to the charging instructions of the rechargeable

battery manufacturer.

• Improper handling (e.g., incorrect rechargeable battery type) can lead to

overloading or destruction of the rechargeable battery.In the worst case, the

battery can explode and thereby cause serious damage.

• Do not charge conventional batteries, rechargeable alkaline batteries (RAM

cells),lead-acid batteries orlithium batteries withthis charger.There isa risk

of explosion.

• Keep transmitting devices (mobile telephones, transmitting systems for scale

models etc.) away from product as the transmitter signal could interfere with

charging and possibly destroy the product and/or the rechargeable battery.

• Never use the product immediately after it has been brought from a cold room

into a warm one. The condensation generated could destroy the product. Allow

the product to reach room temperature before connecting it to an appliance. This

may take several hours.