User manual

101
• Thenthedisplayshowstheindicationwiththeashingmemorynumberagain.
To discard previous settings and cancel setting mode, push the button "BATT. TYPE/
STOP" repeatedly until you are back in the main menu.
The following functions are available:
Depending on the set battery type (LiPo, LiIo, LiFe, NiMH, NiCd, Pb), different setting
functions are available. For example, the setting function for the charge end voltage
per cell is only available for lithium rechargeable batteries.
 Therefore,alwayssettherechargeablebatterytyperstandonlythentheotherdata,
so that the charger can offer the setting functions matching the rechargeable battery
type.
Rechargeable battery type
For this, select the rechargeable battery type "LiPo", "LiIo", "LiFe", "NiMH", "NiCd" or "Pb".
 Asdescribedabove,thisselectionmustbemaderst,sincetherightsettingfunctions
matching the rechargeable battery type are only displayed then.
Battery Voltage
Depending on the set rechargeable battery type, the rechargeable battery voltage can be set
here.
However, it is not possible to set any voltage, but the steps depend on the rated volt-
ageofanindividualcelloftherespectiverechargeablebatterytype;seechapter7.
 Forexample,theratedvoltageofacellinLiPorechargeablebatteriesis3.7V;the
rechargeable battery voltage can thus only be set in steps of 3.7 V (3.7 V, 7.4 V,
11.1 V, etc.).
BATT TYPE
LiPo
BATT VOLTS
7.4V(2S)