Instruction manual
REPLACING OR CLEANING THE HEPA FILTER AND FRAME
1. Remove the dust container by using the open button on the handle.
2. a) Remove the HEPA lter complete with frame from the dust container after releasing
the locking clips on the side of the lter frame.
b) Tap the HEPA lter face down on a at surface covered with a sheet of paper; this
will dislodge excess residue from the HEPA lter. Dispose of the cover sheet with the
dust residue.
3. If necessary, the HEPA lter and frame can be washed with cold water under a tap
(wash from the underside not the topside).
4. Air dry the HEPA lter for approximately 24 hours to ensure it is completely dry before
re-using. Avoid direct sunlight and extreme drying circumstances. If you wish to use
your appliance while the HEPA lter is drying, you can use the spare HEPA lter enclosed
in the packaging carton.
5. a) Ret the HEPA lter and frame by rstly pressing the button on the left hand side of
the dust container.
b) Position the HEPA lter and frame with tab aligning with the button on the side of
the dust container.
c) Insert the HEPA lter and frame, ensuring the locking clips positioned on both sides
of the frame are secured.
1. Insert the dust container back into the cleaner by pressing it down until it clicks.
NOTE: Do not use cleaning agents and avoid touching the delicate lter surface.
8
1.
2.
3.
5.
4.
35125 VORTEX U4015 IFU V3.indd 9 2/10/08 1:37:31 PM