Instruction manual

REPLACING THE FILTERS
• Theltersshouldbereplacedtwiceayearormoreoftendependingontheuseofthe
vacuum cleaner and the dust penetration, which is visible by the discolouring of the lter.
• Disconnecttheelectricalpowercordfromthepoweroutletpriortocleaningthelters.
• Alwaysoperatethevacuumcleanerwiththeltersinstalledtoavoidreductionofsuction
and penetration of dust to the motor.
CLEANING THE MOTOR FILTER
If necessary, the motor lter can be washed or replaced at least twice a year or if clogged,
depending on use.
1. Remove the dust container by using the open button on the handle.
2. Remove the lter from its place.
3. Rinse the lter under tap water and leave it to dry completely (over a
period of 24 hours).
2. Put the lter back into its place.
1. Insert the dust container back into the cleaner by pressing it down until it clicks.
For enquiries on spare parts or for your closest service centre to obtain spare parts, please
contact our customer service help line on 1300 365 305(AUS), 0508 730 730(NZ)
REPLACING THE EXHAUST MICROFILTER
The exhaust microlter should be replaced at least twice a year or if clogged.
4. Open the lter front.
5. Remove the exhaust lter with grill.
6. Take the lter out of the lter grill and insert a new exhaust lter.
5. Put the lter with the grill back into the cleaner.
4. Close the lter grill.
7
1.
2.
3.
4.
5.
6.
35125 VORTEX U4015 IFU V3.indd 8 2/10/08 1:37:30 PM