Instruction manual
REMOVING THE CONTENTS OF THE DUST CONTAINER
Always operate the cleaner with the dust container installed.
1. Remove the dust container by pushing the Open Button on the handle.
2. Remove the contents of the dust container by pushing the orange-coloured
opening button.
3. Close the dust container lid until it clicks.
1. Put the dust container back into the cleaner.
REMOVAL, CLEANING AND FITTING THE PLASTIC CONE ASSEMBLY (Fig. 4)
To ensure there is no restriction of airow resulting in loss of suction after emptying of
the dust container, it is essential that the plastic cone is checked for blockages.
REMOVAL OF THE PLASTIC CONE SECTION
1. Place the dust container upside down with the HEPA lter facing away from you.
2. Open the dust compartment cover ap by pressing the ap release button.
3. The plastic cone assembly is located on the left hand side. Place your thumb and
forenger in the open cavities of the cone assembly, turn clockwise and lift out the
cone assembly.
4. Check for residue build up. If present, wipe clean and replace the cone assembly in the
locking position in the dust container. Turn anti-clockwise to lock it in position. (Please
note that the cone assembly can only be tted one way.)
5. Close the ap and install the dust container in the vacuum cleaner body, ensuring it is
locked into position.
Please note:
it is normal for the red light of the indicator to icker ON and OFF
during use. If the dust container is emptied and the indicator is still ickering,
this indicates the HEPA lter and frame is clogged. In this case follow instructions
replacing or cleaning the HEPA lter and frame – page 8 of this booklet.
6
1.
2.
3.
4.
35125 VORTEX U4015 IFU V3.indd 7 2/10/08 1:37:28 PM