Vortex U4015 Instruction Manual 35125 VORTEX U4015 IFU V3.
Thank you for choosing a Volta Vortex vacuum cleaner. These operating instructions cover all Vortex models; this means that with your specific model, some accessories may or may not be included.
ACCESSORIES AND PRECAUTIONS 2. 1. ACCESSORIES 1. HEPA filter 2. Telescopic tube 3. Hose 4. Hose handle with suction control 5. Dual purpose floor nozzle 6. Upholstery nozzle with plush plate 7. Crevice nozzle 8. Turbo nozzle 9. Accessory holder 10. Hard floor tool IMPORTANT SAFETY INSTRUCTIONS READ ALL INSTRUCTIONS BEFORE USING (THIS APPLIANCE) When using an electrical appliance basic precautions should always be followed, including the following.
Warnings Continued 13. Use extra care when cleaning on stairs. 14. Do not use to collect flammable or combustible liquids such as gasoline or use in areas where they may be present. 15. Unplug the appliance prior to connecting the hose. 16. Do not collect anything that is burning or smoking such as cigarettes, matches or hot ashes. 17. Do not use without filters in place. 18. Do not use extension cords or outlets with inadequate current carrying capacity. 19.
BEFORE STARTING 1. 2. 1. 2. 3. 4. 5. 6. 7. Always operate the cleaner with the dust container installed. Fitting and Removal of the Hose Assembly: - To connect the hose to the suction inlet, insert the hose until it clicks into position. Remove the hose from the suction inlet by pushing the button on the coupling to disengage the securing lock and withdraw the hose from the inlet. Attach the telescopic tube to the hose bent end handle and to the floor nozzle.
REMOVING THE CONTENTS OF THE DUST CONTAINER Always operate the cleaner with the dust container installed. 1. Remove the dust container by pushing the Open Button on the handle. 2. Remove the contents of the dust container by pushing the orange-coloured opening button. 3. Close the dust container lid until it clicks. 1. Put the dust container back into the cleaner. 1. 2. REMOVAL, CLEANING AND FITTING THE PLASTIC CONE ASSEMBLY (Fig.
REPLACING THE FILTERS • 1. • • The filters should be replaced twice a year or more often depending on the use of the vacuum cleaner and the dust penetration, which is visible by the discolouring of the filter. Disconnect the electrical power cord from the power outlet prior to cleaning the filters. Always operate the vacuum cleaner with the filters installed to avoid reduction of suction and penetration of dust to the motor.
REPLACING OR CLEANING THE HEPA FILTER AND FRAME 1. 2. 3. 1. 4. 5. 2. 1. Remove the dust container by using the open button on the handle. a) Remove the HEPA filter complete with frame from the dust container after releasing the locking clips on the side of the filter frame. b) Tap the HEPA filter face down on a flat surface covered with a sheet of paper; this will dislodge excess residue from the HEPA filter. Dispose of the cover sheet with the dust residue.
CLEANING THE HOSE AND NOZZLE The vacuum cleaner stops automatically if the nozzle, tube or hose becomes blocked or if the filters are blocked. This is due to a safety precaution which prevents the motor overheating. Switch off the cleaner at the mains power outlet and remove the plug from the power outlet, grasping the plug not the cord for removal. Allow the cleaner to cool down for approximately 30 minutes. TUBES AND HOSE 1. Use a flexible hose or similar item to clear the tube and hose. 2.
TROUBLE SHOOTING AND CUSTOMER INFORMATION TROUBLESHOOTING THE VACUUM CLEANER DOES NOT START. 1. Check that the power cord is connected to the mains. 2. Check that the plug and power cord are not damaged. 3. Check for a faulty / blown fuse. THE VACUUM CLEANER STOPS 1. Check whether the dust container is full. If so, empty it. 2. Is the nozzle, tube or hose blocked? 3.
WARRANTY For sales in Australia and New Zealand APPLIANCE:VOLTA BRAND VACUUM CLEANERS This document sets out the terms and conditions of product warranties for Volta branded appliances. It is an important document. Please keep it with your proof of purchase documents in a safe place for future reference should you require service for your Volta appliance.
KEEP THIS FOR YOUR RECORDS To be completed by the Purchaser Model Serial No Date of Purchase Retailers Name Retailers Address City State Attach Your Purchase Receipt Here Electrolux Floor Care and Small Appliances Electrolux Pty Ltd ACN 000 015 136 13 Gilbert Park Drive, Knoxfield Victoria, Australia, 3180. Ph: (03) 8756 7300 www.electrolux.com.au Electrolux Floor Care and Small Appliances A division of Electrolux (NZ) Limited 130 Cryers Road, East Tamaki, Auckland New Zealand. Ph: (09) 273 8340 www.
