Campus U4700 & U4702 Instruction Manual
IMPORTANT SAFETY INSTRUCTIONS 13. Use extra care when cleaning on stairs. 14. Do not use to pick up flammable or combustible liquids, such as gasoline, or use in areas where they may be present. 15. Unplug before connecting the hose. 16. Do not pick up anything that is burning or smoking, such as cigarettes, matches, or hot ashes. 17. Do not use without dust bag and/or filter in place. 18. Do not use extension cords or outlets with inadequate current carrying capacity. 19.
S PARTS IDENTIFICATION 5 4 3 7 6 9 8 10 1. 2. 3. 4. 5. 6. Dust bag Textile Dust bag Telescopic extension tube Hose Hose handle with suction control Dual purpose floor nozzle 7. Upholstery nozzle (on board) Crevice nozzle (on board) Dusting brush (on board) 8. Turbo nozzle 9. Variable suction control 10. Hard floor nozzle (Optional purchase item) 2.
ASSEMBLING THE VACUUM CLEANER BEFORE STARTING 7. 1. Open the dust bag cover. Adjust the suction power using the linear potentiometer button on the vacuum cleaner or the suction control on the hose handle. GETTING THE BEST RESULTS 2. Check that the dust bag is in place. 3. Insert the hose until the catch clicks to engage. Press the catch to disengage for removal. 4. Attach the extension tube to the hose handle and the floor nozzle. 5. Pull out the cable and plug it in.
INSTRUCTIONS FOR USE REPLACING THE DUST BAG Warning: On collection of proprietary carpet conditioning powders, plaster / concrete dust, it is recommended that the dust bag is changed. Some of the preparations contain substances which while left in the vacuum cleaner for extended periods, could create damage. Many air fresheners, household deodorants, sprays and polishes contain highly inflammable gas propellants.
MAINTENANCE ➚ REPLACING THE TEXTILE DUST BAG 1. 2. 1. Pull the dust bag upwards and remove the motor protection filter. 2. Rinse the filter under tap water and dry it completely. 3. Put the filter back into the cleaner and close the cover Remove the hose and open the dust bag compartment lid. Holding the bag plate, remove the dust bag from the holder. ➚ 3. Slide the clip away from the bag to open and empty. Replacement Filter part number: Menalux D24.
MAINTENANCE Cleaning the floor nozzle 5. Close the filter cover. 3. Replacement Filter Part number: Menalux D09. Note: Do not use cleaning agents and avoid touching the delicate filter surface. CLEANING THE HOSE AND NOZZLE The vacuum cleaner stops automatically if the nozzle tube or hose becomes blocked, or the filter and dust bag are blocked. Disconnect from the mains and allow to cool down for approximately 20 – 30 minutes.
Troubleshooting and customer information Trouble Shooting Power Customer Information Should you require service or consumable spares for your Volta cleaner, please consult the Blue Ribbon service providers listing enclosed with this cleaner, for your nearest Volta authorised service provider or contact the customer service help line noted on the last page of this instruction manual. New filters and dust bags can be obtained from your Volta authorized service provider.
WARRANTY for sales in Australia and New Zealand APPLIANCE: VOLTA BRAND VACUUM CLEANERS WARRANTY This page sets out the terms and conditions of product warranties for Volta branded vacuums from the Electrolux Group. Please keep with your proof of purchase documents in a safe place for future reference should you require service for your Volta appliance.
KEEP THIS FOR YOUR RECORDS TO completed by the Purchaser Model Serial No Date of Purchase Retailers Name Retailers Address City State Attach Your Purchase Receipt Here Electrolux Floor Care and Small Appliances Electrolux Pty Ltd ACN 000 015 136 13 Gilbert Park Drive, Knoxfield Victoria, Australia, 3180. Ph: (03) 8756 7300 www.electrolux.com.au Electrolux Floor Care and Small Appliances A division of Electrolux (NZ) Limited 130 Cryers Road, East Tamaki, Auckland New Zealand. Ph: (09) 273 8340 www.
