User manual

VoloAccess™ User Manual
Copyright © Vololink Pty Ltd 2006-2010 V1.43 July 2010 Page 49 of 78
System
The System page displays System Information and allows the configuration System Settings.
From the Navigation panel, select System - the System page appears.
Under the System Information heading the following items appear:
Model Name
This is the Model Name of the VoloAccess.
System Uptime
The lapsed time since the VoloAccess was powered on.
Firmware Version
The Version Number of the Firmware installed on the VoloAccess.
Serial Number
The Serial Number of the VoloAccess.
Factory Config ID
The ID of the factory configuration that the VoloAccess will revert to
when Reset to Factory Defaults.
Under the System Settings heading the following items appear:
Admin Password
The default password for the VoloAccess is "password". This should
be changed to protect access to your VoloAccess. (see below).
Remote access to Admin
Enable/disable remote access to Admin using the WAN IP Address
(see below).
Language
Select the Language from the drop-down list.
To change the Admin Password:
● Enter the new password in the editbox, and then click the Apply button.
● You are prompted to Log in using the new password.
● Enter the new password and click the OK button.
If Remote Access to Admin is enabled, it is recommended that you change the default password to
prevent unauthorized access.
To enable/disable Remote Access to Admin:
● Select Enabled or Disabled from the dropdown list. You can also define the port that Remote Access
will use. The default value is port 80.
● Click the Apply button.