User manual

VoloAccess™ User Manual

Telephone

This section, including Supplementary Services, applies only to Voice Enabled models of the VoloAccess.

To configure operation of the telephone select Telephone from the Navigation panel - the Telephone page

is displayed:

Telephone Settings

The following settings can be configured:

Volume

This is the handset earpiece volume (1- quiet, 4 – loud).

DTMF Dial Timeout

Define the time from dialling to call setup. This is the time lag between when

you finish keying the number to call, and when the phone starts to dial. The

timeout range is between 2 and 10 seconds. The default setting is 3 seconds.

Country/Region

Select from the drop-down list.

Line Reversal

If a Private Automatic Branch eXchange (PABX) is connected to one of the

VoloAccess phone ports, it may be necessary to enable this feature as some

features of a PABX require Line Reversal to clear down the line or help hang

up the call. This feature is required when a PABX is using PSTN as opposed

to ISDN. To enable Line Reversal, select Enabled from the drop-down list.

Default Dial

Default Dial is a number that can be configured for the VoloAccess to dial automatically after a defined

timeout simply by lifting the handset. This feature can be used as an emergency call facility. To implement

this feature, Enable Default Dial using the drop-down list then click Apply.

● Enter the Default Dial Timeout (in seconds) and the Default Dial number then click the Apply button.

The valid range for the timeout is between 0 and 10 seconds. The default setting is 5 seconds.