User manual

VoloAccess™ User Manual
Copyright © Vololink Pty Ltd 2006-2010 V1.43 July 2010 Page 33 of 78
VPN
The VoloAccess can be configured as a VPN (Virtual Private Network) Host. To do this, proceed as follows:
● Select LAN followed by VPN in the Navigation panel - the VPN Page appears:
● Select Enabled from the drop-down list and proceed to configure VPN.
● Click the Apply button
You will need to obtain the following information from the administrator of the remote server:
● Remote Host Address
● Remote Network Address
● Remote Network Mask
● Remote Network Gateway
● Authentication Key – A Pre-Shared Key (PSK)
The VPN is implemented using IPsec in Network-to-Network mode. This means that the VoloAccess
is a VPN router providing connectivity between two LANs.
Currently, the supported settings are authentication via pre-shared key using SHA1, with 3DES
encryption. The Diffie-Hellman group is modp1024.