User manual

VoloAccess™ User Manual
Copyright © Vololink Pty Ltd 2006-2010 V1.43 July 2010 Page 27 of 78
The WAN Ethernet page displays the following information:
Network Status
Displays the following:
- WAN Ethernet interface connection status
- the IP Address allocated to the VoloAccess on the Ethernet WAN
- the Subnet Mask
- IP address of the WAN Ethernet Gateway
- IP addresses of the Domain Name Servers (Primary and Secondary)
- MTU (Maximum Transmission Unit).
Traffic Statistics
The number of packets and bytes received (RX) and transmitted (TX).
Settings
The Operating Mode of DHCP should be suitable for most users, however these
items can be configured if necessary. To configure these settings, select Manual
as the Operating Mode.
Operating Mode
From the drop-down list box select the Operating Mode.
The options are:
 Disabled – The Ethernet interface is disabled
 Bridged – The WAN Ethernet port is bridged and operates as a LAN port.
In this configuration, the VoloAccess is a 5 port switch
 Manual – The Ethernet interface can be configured manually
 DHCP – The Ethernet interface will be configured via DHCP
MAC Address
The MAC address of the VoloAccess WAN Ethernet interface
IP Address
The IP Address for the VoloAccess to use on the Ethernet WAN
Netmask
The Netmask of the Ethernet WAN