User Manual

5
ENGLISH
OperatOr’s Manual
troubleShooting
Problem It might be caused by Course of Action
The unit is on, but not heating. The inset may be too small or may not be induction-
ready.
Make sure the inset is induction ready. See the
FUNCTION and PURPOSE of this manual.
The digital display lights are ashing. No induction-ready inset in unit. Place induction-ready inset in the unit.
The unit suddenly stopped working.
The unit may be too close to an external heat source
or the air intake may be restricted.
Relocate the unit away from any external heat
source. Clear any obstructions to the air intake.
The overheat-protection feature may have activated. Remove inset. Let cooking surface cool.
Flashing Message (F code) It might be caused by Course of Action
Add Pan (Add Pan)
No inset has been detected on the induction
retharmilizer.
Place induction-ready inset in the heating area..
Bad Pan (Bad Pan - F9)
The inset may be too small or may not be induction-
ready.
Make sure the inset is induction ready. See the
FUNCTION and PURPOSE of this manual.
TOO HOT
The overheat-protection feature may have activated.
Remove cookware. Let cooking surface cool. Clear
any obstructions to the air intake.
BAD FLO (Bad Flow - F8)
The unit may be too close to an external heat source
or the air intake may be restricted.
Relocate the unit away from any external heat
source. Clear any obstructions to the air intake.
HT SNC (Heat Sync - F4)
The overheat-protection feature may have activated.
Remove inset. Let cooking surface cool. Clear any
obstructions to the air intake.
HT TH (Heat Therm - F5)
The overheat-protection feature may have activated.
Remove inset. Let cooking surface cool. Clear any
obstructions to the air intake.
HOT (Too Hot - F2)
No defect. Indicates the heating area is hot after a
heating cycle has completed.
Restart with inset in correct location. Allow time for
the heating area to cool. (about 5-10 minutes)
The overheat-protection feature may have activated.
Remove cookware. Let cooking surface cool. Clear
any obstructions to the air intake.
Service and rePair
There are no user serviceable parts within this appliance. To avoid serious injury or damage, never attempt to repair the induction range or replace a damaged
power cord yourself. Do not send units directly to the Vollrath Company. Please contact the qualied professional repair service listed below.
VOLLRATH Induction Repair Service • 1-800-825-6036 (USA) or www.vollrathco.com
When contacting the Authorized Professional Service Center, please be ready with the model number, serial number, and proof of purchase showing the date
the unit was purchased.