User manual

VOLKTEK NSH-580 MANAGED 24-PORT 10/100 + 4 G COMBO L3 SWITCH

8.3.19.5 show gvrp portstate

To show gvrp statistics IFNAME status.

CLI Syntax: show gvrp portstate [IFNAME] VID

Example: Switch#show gvrp portstate fastethernet1/0/1 1

8.3.20 CoS/QoS

8.3.20.1 queue cos-map

Use the ‘queue cos-map configuration’ command on the switch to select the CoS queue

that a given priority should map into.

CLI Syntax: queue cos-map PRIORITY QUEUE

Example: Switch(config)#queue cos-map 1 3

8.3.20.2 show queue cos-map

This command shows the information of CoS and priority mapping.

CLI Syntax: show queue cos-map

Example: Switch#show queue cos-map

8.3.20.3 qos mode

This command sets qos mode to high_first mode.

CLI Syntax: qos mode high_first

Example: Switch(config)#qos mode high_first

8.3.20.4 show qos mode

This command shows the qos mode.

CLI Syntax: show qos mode

Example: Switch#show qos mode

8.3.20.5 qos egress bandwidth

This command is used to set the QoS bandwidth informational parameter for the

outgoing packets.

CLI Syntax: qos egress bandwidth LIMIT_RATE

Example: Switch(config)# interface fastethernet1/0/2

Switch(config-if)#qos egress bandwidth 100