User manual

VOLKTEK NSH-580 MANAGED 24-PORT 10/100 + 4 G COMBO L3 SWITCH
CLI Syntax: clear lacp counters [STACKID]
Example: Switch#clear lacp counters 1
8.3.11.2 lacp aggregation-link trunk
This command sets the Link Aggregation Control Protocol (LACP) operation add/set for
the trunk group ports on the switch.
CLI Syntax: lacp aggregation-link trunk STACKID (add/set) group <1-32> PORTLIST
Example: Switch#lacp aggregation-link trunk 1 set group 1 25,26
8.3.11.3 disable lacp aggregation-link trunk
This command sets the Link Aggregation Control Protocol (LACP) operation add/set or
disable for the trunk group ports on the switch.
CLI Syntax: lacp aggregation-link trunk STACKID disable port-number
Example: Switch#lacp aggregation-link trunk 1 disable 26
8.3.11.4 lacp port-priority
This command sets the port priority for the Link Aggregation Control Protocol (LACP) on
the switch.
CLI Syntax: lacp port-priority <1-65535>
Example: Switch(config)#interface giga1/0/26
Switch(config-if)#lacp port-priority 1000
8.3.11.5 lacp system-priority
This command sets the system priority for the Link Aggregation Control Protocol (LACP)
on the switch.
CLI Syntax: lacp system-priority <1-65535>
Example: Switch(config)#lacp system-priority 20000
8.3.12 Mirroring
8.3.12.1 mirror mode
To set port mirror mode (layer 2).
CLI Syntax: mirror mode
Example: Switch(config)# mirror mode enable
89