User manual

VOLKTEK NSH-580 MANAGED 24-PORT 10/100 + 4 G COMBO L3 SWITCH
loadbx none none load binary file over serial line (X modem)
netmask mask xxx.xxx.xxx.xxx set network mask
ping host xxx.xxx.xxx.xxx send ICMP ECHO_REQUEST to network host
pwd none none reset switch password
reset none none perform reset of the CPU
serverip IP address xxx.xxx.xxx.xxx set tftp server IP address
slot slot 1, 2, auto select boot slot to boot
tftpboot filename Example:
3112single.img
load image via network using TFTP protocol
version none none print monitor version
Boot ROM commands
8.2 Login and Logout
To enter the CLI mode, a valid user name and password must be entered. For the first
login, the user can enter “admin” as the user name (without password). For security
reasons, please change the user name and password after login. If you forget the user
name and password, you may contact the support team or restore the default user
account in the Boot ROM Command mode – “pwd”. If you select the second choice, the
default username “admin” will be restored.
Type “exit” to leave the CLI mode safely. This action allows the user to secure the CLI
mode. The next user has to log in again with an authorized user name and password.
8.3 CLI Commands
The Switch provides CLI commands for all managed functions. The user can follow the
instructions and set up the switch correctly as easily as using WEB interface to configure
the switch.
Note: Always use “?” or “list” to get the available commands list and help.
Always use “end” to get back to the root directory (enable mode).
8.3.1 User Account
8.3.1.1 Add user
Add a new user or modify an existing user’s password.
CLI Syntax: add user user-name password
Example: Switch(config)#add user admin 123
79