User manual

VOLKTEK NSH-580 MANAGED 24-PORT 10/100 + 4 G COMBO L3 SWITCH
Auth Password: enter the password that the Auth Protocol belongs. The password
needs at least 8 characters or digits.
Priv Protocol: enter the Priv Protocol that SNMP User and Security Group belong.
Only NoPriv, DES can be chosen. If the NoPriv is chosen, there is no need to enter
password.
Priv Password: enter the password that the Priv Protocol belongs. The password
needs at least 8 characters or digits.
Security level: enter the Security level Name that the Group belongs. Only NoAuth,
AuthNopriv, AuthPriv can be chosen.
SNMPv3 VGU Table – Users
7.9 ACL
The switch can set Access Control List rules to filter certain traffic types according to
packet header information from Layer 2 to Layer 4. Each filter set includes a couple of
rules. The user should attach the filter set to certain ports to make the filter work.
7.9.1 Set Access Control List
The Switch defines two modes of rules, one is MAC mode and the other is IP mode.
Only the same mode of rules can bundle together to form a filter set. Each mode has
different fields to configure. For example, the user can use the IP mode rule to filter FTP
packets.
The user can check the MAC Filter, give it a Name then add it. The user also can check
the IP Filter and give it an ID/Name, then click on Add. Click Submit to save the
configuration permanently or Refresh to refresh the page. Please click Edit before
66