User manual

VOLKTEK NSH-580 MANAGED 24-PORT 10/100 + 4 G COMBO L3 SWITCH

7.6.3.1 OSPF – Basic

The user can use this page to add L3 interfaces to specific OSPF areas.

IP Address: All active L3 interfaces are displayed – you can select any one to

configure as OSPF interface

Area : Specify the area ID for a specific L3 interface

Clicking the Advanced >> button adds extra buttons for “Interfaces” and “Area” options

next to the “Basic” button.

OSPF – Basic

7.6.3.2 OSPF – Interfaces

This function is used to specify some protocol parameters for a specific OSPF interface

Network Type: Support broadcast only

Cost: Specify the cost for sending packet of this interface

Priority: Set priority to help determine the OSPF DR and BDR for a network

Transmit Delay: Set the estimated number of seconds to wait before sending a link

update packet

Hello Interval: Set the number of seconds between two hello packets, 10 seconds is

set as default value

Dead Interval: Set the number of seconds after the last hello packet was received

before declare its neighbor OSPF router is down; the default value is 40 seconds.

Retransmit Interval: Specify the number of seconds between transmitting link state