User manual

VOLKTEK NSH-580 MANAGED 24-PORT 10/100 + 4 G COMBO L3 SWITCH

Configure the Static Route

7.6.2 RIP

This function is used to switch on/off RIP routing protocol. Clicking will enable

configuration of Passive-Interfaces and RIP version (v1/v2/both). When RIP is turned on,

the switch will exchange routing information with neighbor switches which also running

RIP.

7.6.2.1 RIP – Basic

The RIP function can be enabled/disabled for all Layer 3 interfaces. All active L3

interfaces will be shown on the screen and the RIP function can be enabled/disabled for

each interface. Clicking the Advanced >> button will show the other RIP options as

discussed in later sections.