User manual

VOLKTEK NSH-580 MANAGED 24-PORT 10/100 + 4 G COMBO L3 SWITCH

Router Reports

Routing Protocol: the routing protocol type of the route. If it is “connected”, the

destination is on the local LAN segment connected to the interface

Destination: destination IP address. It will be masked to generate an IP range as the

objective IP addresses of packets to be routed.

Mask: the mask for generating a range of IP addresses.

Connected via: IP address of the next router for routing to another network.

Interface: the interface or VLAN ID from which the packets are routed outside.

7.6 Routing

7.6.1 Static Route

This function is used to add a routing entry into the switch routing table. The routing

entry added this way will never be deleted by the system, so it is called a static route.

Following parameters must be input to configure static route:

Destination: Input destination IP address.

Netmask: Input subnet mask of the destination for generating the IP range to be routed.

Gateway IP: Input gateway IP address as the next router the packets to be sent to.

Metric: Input metric (1-15). The lower the metric value is the more preference of the

route.

Click on Add when you add a new static route and you will see the new added entry

shows in the list window. You can remove the selected route by clicking Remove. The

routes that are added or removed will be stored in the configuration file immediately.