User manual

VOLKTEK NSH-580 MANAGED 24-PORT 10/100 + 4 G COMBO L3 SWITCH
99
8.3.24 Dial-in User
8.3.24.1 dot1x username password
Add user into local radius database.
CLI Syntax: dot1x username WORD passwd WORD vlan
Example: Switch(config)#dot1x username test passwd 12345 vlan 1
8.3.24.2 show dot1x user
Show dot1x dial-in user.
CLI Syntax: show dot1x username
Example: Switch#show dot1x username
8.3.25 RADIUS
8.3.25.1 RADIUS settings
This command sets the radius server ip, radius key, and radius port for 802.1X configuration.
CLI Syntax: dot1x radius server-ip A.B.C.D key RADIUS_KEY [PORTID]
Example: Switch(config)#dot1x radius server-ip 192.168.1.38 key
123456 1812
8.3.25.2 show dot1x radius
Show dot1x radius server ip, radius key, and radius port for 802.1X configuration.
CLI Syntax: show dot1x radius
Example: Switch#show dot1x radius
8.4 Miscellaneous commands
show modelname: shows the model name of switch.
show version: shows the hardware, boot rom and firmware version.
ping: ping remote host
show vlan_all: display vlan
show ip route: display the entries in the routing table