User`s manual

VOLKTEK IRF-633 RS-232/422/485 TO 100BASE-TX DEVICE SERVER

set idle - (time in seconds) – set automatic logout. when the program or

communication is idle

set xfer - the command is for RS-232 configuration and data communication

setting. The command syntax is as below.

set xfer [arg_1 data_1] [arg_2 data_2] ...

[arg_n data_n]

[Argument List]

Port........... Set TCP port number

statistics..... Clear statistics

upgrade - Use this command to upgrade the firmware.

i.e upgrade firmware xxx.xxx.xxx.xxx Soft2.bin

set snmp - Use this command to set SNMP settings of the device server.

After each configuration session, be sure to set DIP switch 1 to the

‘OFF’ position. Otherwise, the unit will not transmit any data.

6.3 Web Graphic User Interface

Please see previous chapter to log-in the Device Server / Managed Media Converter

via web browser.

6.3.1 System Information

System information will show IP Address, Subnet Mask and Gateway settings. After

editing the setting press Apply to implement the settings.

6.3.2 Master Information

Master Info will show the hardware and firmware version.