User`s manual

VOLKTEK IRF-633 RS-232/422/485 TO 100BASE-TX DEVICE SERVER

6.2 Command Line Interface

Once you logged in and select the option of Command Line Interface, a window with

command prompt will appear. Type ? or help and it will show you the command list.

Command List

Command Definitions

backup: Use this command to save configuration settings

to file.

exit: Type exit or logout and press ENTER to quit the program.

help: To access help commands list.

logout: To logout from the device server.

ping: Type ping followed by a space, and then the IP address of the device to

send a test signal. If a response is received, then the device is connected. To

view a full list of ping options, type ping and press ENTER.

reset: Type reset config and press ENTER to load factory default settings, or type

reset system and press ENTER to restart the system.

show: Type show to display variety of device server settings.

set: To configure the management settings, type the commands below, followed

by the ENTER key.

NOTE: Separate each port of the command line with a space.

set admin - follow the prompts to change user name and password

set eth0 - the command is for factory setting use set eth0 ip (new IP address)

network mask (new network mask) gateway (new gateway). Use this

command to set new Ethernet settings.