User`s manual

VOLKTEK IRF-633 RS-232/422/485 TO 100BASE-TX DEVICE SERVER
10
4. Press ENTER and on the following screen, type the default username admin, leave
the password field blank since there is no default value and press ENTER to
proceed.
5. Select either CLI User Interface or Menu-driven Interface option by using the
associated number key or using the TAB key and pressing ENTER. A relevant
Main Menu screen appears.
The Device Server / Managed Media Converter is preset with a factory IP address
(192.168.0.254) that must be configured to the user’s individual IP address. It is
important to do this so that the device server / managed media converter doesn’t
conflict with other devices with the same defaults.
NOTE:
Prior to following the instructions for HyperTerminal Configuration, ensure that a serial
cable connection between the device server / managed media converter and
workstation exists.
Type the following command line to change the device IP address in CLI mode where
xxx’s represent values between 0 and 254 and the user should enter their own IP
address in this form.
a) set eth0 ip xxx.xxx.xxx.xxx