User manual

17
 Recommended Procedure for configuring and setting
DIP switches during initial installation:
1. Turn all DIP switches OFF.
2. Install the INS-802 into your network.
3. Decide which port(s) need to be monitored or
should trigger the alarm.
4. Turn the corresponding port DIP-switch ON.
5. Activate the Switch.
Fiber Connector
The dual Fiber Ports on the INS-802 are LC-type SFP
modules in either multi-mode or single mode (sold
separately). The Switch’s fiber switched ports operate at
a fixed 100Mbps speed and full-duplex mode to provide
the best performance.
When plugging the LC-type SFP module into the port,
make sure the module is aligned correctly and press the
module into the receptor so that it fits snugly into the port.
The 100Base-FX and the 10/100Base-TX ports are all
fully switched ports, with the dual fiber uplinks providing a
high bandwidth, daisy-chainable backbone connection
that supports long fiber cable distances (up to 2km for
multi-mode, and 60km for single mode).
Auto-negotiation
The INS-802 Industrial Switch’s 10/100Mbps switched
RJ-45 ports auto-negotiates with connected devices to