User manual

LED does not light up

PROBLEM SOLUTION

The LED flashes correctly but

you do not see 3D images

Ensure the USB power cable or the VESA

cable is connected.

Red continuous light

The system is powered but there is no synchroni-

zation signal.

If sync via DLP-Link : ensure the 3D mode is

selected in the setup of your 3D projector.

If sync via VESA : ensure the 3D mode is

selected in the setup of your 3D synchronization

source.

Ensure the SmartCrystal

Pro is facing the right

way, the face with the inscription “PROJEC-

TOR SIDE” should be facing towards the

projector. Other potential sources of the

problem : the projection screen is not

3D-capable, content is not in 3D, or the

projector is still running in 2D mode.

6. TECHNICAL SPECIFICATIONS

1- Window Size: 74 x 68mm (2.9x2.7 inches)

2- Maximum power of projector: 5,000 lumens

3- Synchronization Power consumption: < 500mW

4- Maximum switching speed: 144Hz

5- Upgradable software for optimal 3D performance

6- Optical light efficiency: > 16%

7- Operating temperature: +10°C to 55°C (50°F to 131°F)

8- Storage temperature: -10°C to 55°C (14°F to 131°F)

9- Dimensions: 120 x 120 x 30mm (4.7 x 4.7 x 1.18 inches)

10- Weight: 500 g (17.6 oz)

11- Aluminium

12- Mount accessory

7. LED SIGNAL

Red continuous light: The system is powered but not synchronized.

Green continuous light: signal of 2D synchronization (less than 96Hz)

Green flashing light: signal of 3D synchronization (greater than 96Hz)

8. TROUBLESHOOTING