Specifications

10.

7. CONFIGURATION AND HEIGHT ADJUSTMENT.

The system is designed in order to be able to make a height adjustment the rst time the system is installed so that the equipment

matches the projection alignment axis of the Projector - 3D System - Window projection.

This is a simple operation that once made, will remain unchanged for both 2D and 3D mode.

Please proceed as follows:

1. - Measure the height from the oor to the center of the digital projector lens. (X)

2. - Ensure the window of the SmartCrystal™ Cinema Polarizer Module is lowered into the mechanical-housing and set, as indicated below,

the height of the equipment to the value closest to X - minus 15 cm (i.e X – 15 cm). To do this proceed as follows :

2.1.- Unscrew the 8 screws shown. (4 on each side): Remove screws to adjust the height of the system. Tighten into position. X – 15 cm

2.2.- raise the black mechanical housing on the side guides to the position closest to the value calculated above and ret the four screws

as shown.

Remove screws to adjust the height

Tighten into position.

X – 15 Cm

Also, there are some openings in the base to facilitate this operation.