User Manual

9 / 12
The airplane comes with one-key U-turn function, which enable the plane to U-turn by
the opposite direction that the airplane takes off.
Follow below steps to activate the function.
1. Place your plane heading to the take-off direction.
2. Do NOT unlock the throttle, press the activation button and hold for several seconds
until you hear a "beep" sound, the rudder surface will respond, meaning the one-key
U-turn function is now activated.
NOTICE: Every time when you power on the plane, it requires to activate the one-key
U-turn function.
To use this function during ight, press the one-key U-turn switch button,the plane will
turn around automatically, back to the opposite direction where it takes off.
To quit, just press again the switch button, or control
any servo stick(rudder/elevator), the plane will back to
your control immediately.No matter you ies the plane
under manual control or X-PILOT assist mode, when
you turn on the one-key U-turn function, the plane will
enter X-PILOT assist mode automatically to help
stably ying back. When you quit this function, the
airplane will back to the what the control mode it was.
CAUTION: This function is bound to the receiver,
instead of to the transmitter, which means the plane will U-turn ONLY to the opposite
direction that the plane takes off. It also means when the plane U-turns and passes the
position where you activated the function, the one-key U-turn function will NOT U-turn
the plane back to the take-off position.
One-key U-turn Instruction
X-PILOT System Calibration
1.Turn the throttle stick to min position.
2.Power on the transmitter and the receiver.
3.Do NOT unlock the throttle.
4.Keep the sticks as above picture for several seconds.
5.When you hear a “beep” sound, it means the X-PILOT
system is calibrated based on the horizontal level you are
keeping it.
One-key U-turn
Activation
One-key U-turn
Switch