User Manual

7 / 12
The airplane comes with pre-installed
X-PILOT to help control ying easily.
The switch is with 3 levels to control the
X-PILOT. To turn on the X-PILOT, switch
to upper position(towards you). To turn off
the X-PILOT, switch to lower position(away
from you).
CAUTION: It is strongly suggested to turn
on X-PILOT while ying the airplane.
Binding Instruction
X-PILOT Switch
Binding is the process of programming the receiver to recognize the
GUID (Globally Unique Identier) code of a single specic transmitter. When a receiver
is bound to a transmitter, the receiver will only respond to that specic transmitter.
If you need to rebind for any reason, please follow these steps:
1.Keep the transmitter switched OFF, throttle joystick at buttom position.
NOTICE: Keep X-PILOT switch at Middle or Beginner position.
NOTICE: Keep the plane still in a calm environment for calculating the X-PILOT.
2.Connect the battery to the plane, then turn on the transmitter within 5 seconds.
3.The receiver LED will ash for 3-8 seconds to bind automatically.
4.After the receiver LED stop ashing, it means the binding process is done.
Follow below steps when you operate a bound plane:
1.Power on transmitter rst.
2.Connect the battery to the plane within 3 seconds.
3.The receiver LED in plane will ash and then turn to solid in several seconds.
4.Switch the X-PILOT control stick to X-PILOT assist level(MIDD or BEGINNER).
NOTICE: Allow the airplane stay still about 3~5 seconds in a calm environment when
you rst time turn on X-PILOT, in order to calibrate and activate the X-PILOT. When the
X-PILOT starts to react, means it is activated.
5.Turn throttle stick up to max and then down to min to arm the motor.
CAUTION: Do NOT operate around people or property, otherwise it may cause serious
damage!
0 - Away From You- Manual / X-PILOT Off (EXPERT)
1 - At the Middle - Soft X-PILOT Assit (MIDD)
2 - Towards You - Strong X-PILOT Assit (BEGINNER)
Throttle Unlock(Arming)
To prevent from damages, the throttle channel is locked each time when powering on
your transmitter. Follow below instruction to unlock the throttle.
CAUTION: Keep the propeller in distance for your safety.
Turn the throttle stick up to max position until you hear a "beep" sound. Then turn the
throttle stick down to min position until you hear a "beep" sound.
Now the throttle is unlocked.