Owners manual
INS19835
140 Blaze Industrial Parkway, Berea, OH 44017 l P: 440.891.0999 F: 440.891.1868
8
03/21/2018
techsupport@tmgperformance.com l www.volant.com
2017-2018 FORD RAPTOR & F-150 ECOBOOST 3.5L
Closed Box Air Intake
Pro 5 Part #: 19835, DryTech 3D Part #: 19835D, PowerCore
®
Part #: 198356
INSTALLATION INSTRUCTIONS
VOLANT INTAKE
17. Adjust air duct as necessary and tighten all
clamps using a ratchet and 8mm socket or flat
head screw driver. NOTE: Make sure to tighten
the filter clamp as well.
18. Clip wiring harness on air temperature sensor.
19. Install lid using provided 4 truss head screws
with rubber washers and Philips head
screwdriver.
Check that this air intake complies with your Federal, State and Local laws.
We recommend saving your stock system.
BEFORE ROAD TESTING
1. Start engine, leaving the transmission in park and securing the parking brake.
2. Make sure to look and listen for any unusual noises or air leaks. Repair problems if needed.
3. Once completed it will be necessary to check periodically, after a few heat cycles, for realignment and
tightening of all connections.
Pro 5 CARE AND CLEANING
Check the Pro 5 cotton reusable filter periodically and remove any excessive dirt build-up by tapping the
filter on the ground and brushing off the loosened dirt. Clean the filter by using a two stage cleaning kit to
thoroughly clean and re-oil the filter. Re-oil every 10,000 miles without cleaning to improve filtering in sand
and dirt. Clean only when dirt is very excessive or 50,000 miles.
Reference for Replacement Filters:
Pro 5 (Oiled) Part # 5119, DryTech 3D (Dry) Part # 5160, PowerCore® (Dry) Part # 61513