Technical data

25
ENTER
ESCAPE
7.3 SERVICE MODE & PARAMETERS
This boiler is equipped with a new generation of electronic boards,
which allow a better personalization by setting / adjusting the
machine’s operating parameters, in order to answer the installation
and/or usage needs. The programmable parameters are indicated
in the table at page 24.
The parameters programming must be done with the boiler
on OFF position. Press the key until you see “ENERGY
FOR LIFE” scrolling on display.
During the parameters programming, the key assumes
the function of ENTER (confirm) and the key the function of
ESC (exit).
If you don’t confirm the setting within 10 seconds, the value is not
memorized and the boiler returns to the value previously set.
Setting the password
By holding down the key and then pressing the key for about
3 seconds, you may access the parameters programming.
The display will show the word PROG and immediately after CODE.
Press ENTER to confirm. Enter the password code for accessing
the parameters adjusting function by turning the selector to obtain
the value required. Confirm password by pressing ENTER.
The password for accessing the parameter programming function
is located on the back side of the control panel.
Modifying parameters
- Turn the selector A to scroll the two number codes of the
parameters indicated in the table.
After identifying the parameter you wish to modify, proceed as
follows:
- press ENTER access the parameter value adjustment function.
When you press ENTER the value previously set is flashing
- turn the selector A to select the value desired
- confirm the new value by pressing ENTER. The digits will stop
flashing
- exit the function by pressing ESCAPE.
The boiler will go back to off mode, to resume operation press the
key.
Fig. 41
A