Technical data

22
rubber condense pipe (C) from the condense trap.
Carefully remove the condense trap. Replace in the reverse order.
6.26 FLUE COLLECTOR REMOVAL (fig. 37)
Carry out component removal procedure as described in 6.4.
Unclip and remove the air chamber front and left side covers. Locate
and remove the screw (A) that secures the flue gas analysis test
point cover (B). Remove the clip and the fumes thermostat. Gently
pull down and to the left and ease the flue collector from its location.
Replace in the reverse order.
Fig. 35
Fig. 36
A
B
A
B
C
A
B
Fig. 37