User manual

AT-323 SIP Phone User Manual (V1.43)
37
will be seen. Fox example:
P:\>ping 203.93.9.57
P:\>
ping OK
P:\>ping 27.56.120.56
P:\>
Note Usually, the echo time of ping command is no more than 1 second. So if the
result is not displayed in 5 seconds, ping command is fail.
¾ Command ftp
Syntax descrIPtion: ftp value
Usage: the system connects to the FTP server auto to get the
corresponding file and deal with it.
Relevant usage: ftp X
X ranged from 0 through 2:
X-0: Connect to FTP Server to get the file of updating program and
save it to the SDRAM of the phone. Then the file can be read by
PalmTool. This operation aims at testing.
X-1: Connect to FTP Server to get the file of updating program and
update program Flash. This operation aims at updating program.
X-2: Connect to FTP Server to get the file of updating dial rules and
update program Flash. This operation aims at updating dial rule.
Note When you use ftp 0 and ftp 1 commands, if the file get from FTP server is too
large or the net speed is too slow, then the process will not be seen in telnet
window. Please be patient. Using ftp command in telnet to get file spends almost
same minutes as getting file using phone. So if nothing is displayed after too long
time, it means that ftp is fail.
Note All the Telnet commands of AT-320 IP phone should be written in low case and the
password is case sensitive.
VoIPon www.voipon.co.uk [e-mail] Tel: [phone] Fax: [phone]