User manual

AG-188 User Manual
2.3 Network
2.3.1 Wan Config
WAN port network setting page.
Support static IP, dynamic obtain IP and PPPoE.
Configure Static IP:
----Enable Static;
----Set AG-188N’s IP address in the IP Address;
----Set net mask in the Net mask field;
----Set router IP address in the Gateway;
----DNS Domain:
----Set local DNS server in the Preferr
ed DNS and
the Alternate DNS
Configure to dynamic obtain IP
----Enable DHCP;
If there is DHCP server in your local network,
AG-188N will automatically obt
ain WAN
port network information from your DHCP server.
Configure PPPoE:
----Enable PPPoE
----PPPoE server: Enter “ANY” if no specified from your ITSP
.
----Enter PPPoE username and pin in the username and pa
ssword.
AG-188N will automatically obtain WAN port network information from your ITSP
if
PPPoE setting and the setup are correct.
Notice: If user accesses the gateway through W
AN port. He should use the new IP
address to access the gateway when the WAN port address was changed.
10 / 42
VoIPon www.voipon.co.uk [e-mail] Tel: [phone] Fax: [phone]