Owner`s manual

Open the drain plugs on both sides of the
engine block.
3. Open the air release plug to drain the
coolant.
4. Flush the cooling system by running fresh
water through the radiator.
5. Close the radiator drain plug and engine
block drain plugs securely.
6. See the ‘‘Technical information’’ section for
cooling system capacity.
Fill the radiator slowly with the proper
mixture of coolant and water. Fill the
reservoir tank slowly up to the ‘‘MAX’’
level. Then install the radiator cap and
close the air release plug.
7. Start the engine and warm it up until it
reaches normal operating temperature.
Then race the engine 2 or 3 times under no
load.
Watch the coolant temperature gauge for
signs of overheating.
8. Stop the engine. After it completely cools
down, refill the radiator up to the filler
opening. Fill the reservoir tank up the
‘‘MAX’’ level.
9. Check the radiator drain plug and engine
block drain plugs for any sign of leakage.
SID0086
SID0087
SID0088
DO-IT-YOURSELF
7-7
Z 96.12.20/ X