Owner`s manual

oncoming vehicle. The light axis can be
lowered with the operation of the switch.
The larger the number designated on the
switch, the lower the axis.
When traveling with no heavy load or on a flat
road, select position 0.
Xenon headlights are extremely bright
compared to conventional headlights. If
the xenon headlights hit the rearview
mirror of the vehicle ahead or the wind-
shield of the oncoming vehicle, the
driver of these vehicles may have diffi-
culty driving because of the brightness.
Use the headlight aiming control switch
to lower the light axis. See “Headlight
and turn signal switch” earlier in this
section for information on xenon head-
lights.
Instrument brightness control
The instrument brightness control operates
when the head light switch is in the
or
position.
Turn the control to adjust the brightness of
the instrument panel lights.
When the control is turned upward until a
click sound is heard, the light intensity will be
at maximum. When the control is turned
downward until a click sound is heard or felt,
the light will be turned off.
Headlight beam select
To select the high beam, push the lever
forward. Pull it back to select the low beam.
Passing signal
Pulling the lever toward you will flash the
headlight high beam.
SII0085
SII0080
INSTRUMENTS AND CONTROLS
2-26
Z 01.9.13/JR50-D X