Owner`s manual

4. Allow the belt to retract. Pull up on the belt
to remove any slack in the belt.
5. Before placing the child in the child
restraint, use force to tilt the child restraint
from side to side, and tug it forward to
make sure that it is securely held in place.
6. Check that the retractor is in the automatic
locking mode by trying to pull more belt
out of the retractor. If you cannot pull any
more belt webbing out of the retractor, the
belt is in the automatic locking mode.
7. Check to make sure the child restraint is
properly secured prior to each use. If the
belt is not locked, repeat steps 3 through
6.
After the child restraint is removed and the
seat belt is allowed to wind back into the
retractor, the automatic locking mode (child
restraint mode) is canceled; the seat belt only
locks during a sudden stop or impact.
Rear facing
WARNING
O The three-point belt on your ve-
hicle is equipped with a locking
mode retractor which must be
used when installing a child
restraint.
SIR0062 SIR0042
SEATS, RESTRAINTS AND SUPPLEMENTAL AIR BAG SYSTEMS
1-41
Z 01.9.13/JR50-D X