Owner`s manual

turer’s instructions for belt routing.
3. Remove all slack in the lap belt for a very
tight fit by pulling forcefully on the lap belt
adjustment.
4. Before placing the child in the child
restraint, use force to tilt the child restraint
from side to side, and tug it forward to
make sure that it is securely held in place.
5. If it is not secure, try to tighten the belt
again, or put the restraint in another seat.
6. Check to make sure the child restraint is
properly secured prior to each use.
INSTALLATION ON REAR SEAT
OUTBOARD POSITIONS
Front facing
WARNING
O The three-point belt in your ve-
hicle is equipped with a locking
mode retractor which must be
used when installing a child re-
straint.
O Failure to do so will result in the
child restraint not being properly
secured. It could tip over or oth-
erwise be unsecured and cause
injury to the child in a sudden
stop or collision.
When you install a child restraint in a rear
outboard seat, follow these steps:
SIR0036
SIR0037
SEATS, RESTRAINTS AND SUPPLEMENTAL AIR BAG SYSTEMS
1-39
Z 01.9.13/JR50-D X