Owner`s manual

break-in period, depending on the se-
verity of operating conditions.
CAUTION
Oil level should be checked regu-
larly. Operating with insufficient
amount of oil can damage the en-
gine, and such damage is not cov-
ered by warranty.
CHANGING ENGINE OIL
1. Park the vehicle on a level surface and
apply the parking brake.
2. Run the engine until it reaches operating
temperature, and then turn it off and wait
more than 10 minutes.
3. Place a large drain pan under the drain
plug.
4. Remove the oil filler cap.
5. Remove the drain plug with a wrench and
completely drain the oil.
If oil filter is to be changed, remove and
replace it at this time. See later in this
section for changing engine oil filter.
CAUTION
Be careful not to burn yourself. The
engine oil will be hot.
O Waste oil must be disposed of prop-
erly.
O Check your local regulations.
6. Clean and re-install the drain plug and a
new washer. Securely tighten the drain
plug with a wrench.
Drain plug tightening torque:
22 to 29 ft-lb (29 to 39 Nzm)
Do not use excessive force.
7. Refill the engine with recommended oil
and install the cap securely.
See “Capacities and recommended
fuel/lubricants” in the “10. Technical and
consumer information” section for drain
and refill capacity.
The drain and refill capacity depends on
the oil temperature and drain time. Use
these specifications for reference only.
Always use the dipstick to determine when
the proper amount of oil is in the engine.
SID0207
DO-IT-YOURSELF
8-8
Z 01.9.13/JR50-D X